Campbell SAT ARGOS Bedienungsanleitung PDF herunterladen (Seite 211)

ZENO

-3200 USER MANUAL

Coastal Environmental Systems (206) 682-6048

Page 203

Time :10 :15 :20 :25 :30 :35 :40: 45 :50 :55 :00 :05 :10 :15 :20 :25 :30 :35 :40: 45 :50 :55

(minutes)

ZENO

Message #1

Message #2

Message #3

Message #4

To set up this sampling scheme, the Sample Period Menu of the User Menu will require the following

values:

 The Sample Interval time will be 1800 seconds, or 30 minutes

 The Sample Duration time will be 60 seconds

 The Sample Offset will be zero––sampling starts at the beginning of each half-hour period

The four Data Output Message Periods will then take the following values as shown in the table below. It

is worth noting that message numbers 1, 3 and 4 are given the same data output message period, but only

message #1 interprets 0 to mean “output at the end of the sampling period.”

Message Number Data Output Message Period

#1 (output at the end of the 1 minute sampling period) 0

#2 (output at the end of the half-hour) 300 seconds (5 minutes)

#3 (output when triggered by an alarm) 0

#4 (not used) 0

10.8. RESETTING (REBOOTING) THE ZENO

-3200

After you have made changes to your configuration, it may be a good idea to reboot the ZENO

-3200 to

ensure that everything has been properly initialized.

Before you reboot the ZENO

-3200, make sure that you save your

configuration to EEPROM! Otherwise, the changes you made will be lost.

There are two ways you can reboot the ZENO

-3200:

 Turn off the power, wait a few seconds, then turn it on again.

 Use menu option R in the Zeno Program Menu.

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 393 394

Keine Kommentare

Campbell SAT ARGOS Bedienungsanleitung Seite 211