Campbell RF410 Bedienerhandbuch PDF herunterladen (Seite 83)

Appendix B. NL100 TcpServer to RF400 to CR510PB-Router/RF400 to 20 CR205s Network

B-3

CR205 Settings

1. Configure all CR205s with the same Radio Address, Net Address, and

Hopping Sequence using the same settings as the RF400s have.

2. Configure each CR205 with a unique PakBus address (“Datalogger

Address” in PakCom) starting with “1” and ending with “20.”

3. Configure Radio Power Mode = RF_ON

4. Configure Radio Force On = 0

CR510 (Router) Settings

Configure the Network settings, and Neighbor Filter in the CR510PB program

using Edlog\Options\PakBus Settings. When the program is sent to the

CR510PB, the program will configure the PakBus settings in the CR510PB.

FIGURE B-1. Edlog CR510 Setup

The Communication Interval could be set ≤ the scheduled collection interval. If

the CR510PB does not hear from a CR205 within 2.5 × this interval, it will

drop the CR205 from its Neighbor List and send hello messages randomly

every 1 to 15 seconds until communications is restored or until you remove the

CR205’s address from the CR510’s potential neighbor list. You could use

PakBusGraph for this.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 123 124

Keine Kommentare

Campbell RF410 Bedienerhandbuch Seite 83