Campbell RF410 Bedienerhandbuch PDF herunterladen (Seite 44)

PakBus Networking Guide

RS-232 port is connected directly to an RF400 Series communicating with

CR200 Series remotes (see Appendix B).

Alternatively, the NL100 can be configured as a PakBus device with a PakBus

Address and beacons enabled:

FIGURE 17. NL100 Configured as PakBus Device

In the above example, both the NL100’s CSI/O port and RS-232 port are

configured for “PakBus” mode.

5.3.1 CS I/O and RS-232

Can be “TcpSer” for transparent operation or “PakBus” (see figure above) to

create a PakBus device.

5.3.2 Beaconing

If you create a PakBus node you can also create a beacon with programmable

interval.

5.3.3 PakSer

Port configuration for a non-PakBus datalogger in the network.

6. Datalogger PakBus Instructions

6.1 CR10X, CR510 and CR23X Dataloggers

Following are summaries of Pxxx instructions pertaining to PakBus networks.

For more information, refer to Edlog Help or datalogger manual.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 123 124

Keine Kommentare

Campbell RF410 Bedienerhandbuch Seite 44