Campbell NL100 Bedienungsanleitung PDF herunterladen (Seite 30)

November 2005, ARM-TR-069

D-8

The logger you added in the above steps will be located in the Stations menu. Highlight the

logger you wish to connect to and click on the connect button on the bottom. If everything is

connected and correct the wires of the Control

display will connect. To send a program to the

logger, click on the Send button under the Program

portion of the Connect screen. Navigate to

the directory where the program is stored (should be C:\SurTHRefPgm) and select the appropriate

program. Once the program has been selected, click on the Send button. A warning banner will

be displayed stating that continuing will cause all data to be lost. Continue to send the program

by clicking on the Ok

button. Once the send is complete and the logger has compiled the

program, another message banner will be displayed, click on Ok

to finalize the transmission.

Once connected and a program is running (assuming sensors connected) you can view the raw

data and final stored data by clicking on the numbers in the Data Displays

section of the Connect

screen.

****A NOTE OF WARNING: CONNECTING TO A LOGGER USING THE CONNECT

SCREEN WILL DISABLE COMMUNICATIONS TO OTHER LOGGERS ON LOGGERNET.

NO DATA WILL BE COLLECTED WHILE YOU ARE CONNECTED THIS WAY.

REGULAR COMMUNICATIONS WILL BE RESTORED WHEN THE CONNECTION IS

SEVERED.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Keine Kommentare

Campbell NL100 Bedienungsanleitung Seite 30