Campbell NL100 Bedienungsanleitung PDF herunterladen (Seite 20)

November 2005, ARM-TR-069

C-5

;R1 probe location

32: Z=F x 10^n (P30)

1: 4 F

2: 0 n, Exponent of 10

3: 38 Z Loc [ R1locate ]

;R2 probe serial number

33: Z=F x 10^n (P30)

1: 92782 F

2: 0 n, Exponent of 10

3: 39 Z Loc [ R2probeSN ]

;R2 probe location

34: Z=F x 10^n (P30)

1: 2 F

2: 0 n, Exponent of 10

3: 40 Z Loc [ R2locate ]

;R3 probe serial number

35: Z=F x 10^n (P30)

1: 92783 F

2: 0 n, Exponent of 10

3: 41 Z Loc [ R3probeSN ]

;R3 probe location

36: Z=F x 10^n (P30)

1: 6 F

2: 0 n, Exponent of 10

3: 42 Z Loc [ R3locate ]

Change the serial number in location 1 (see bold values above) of the appropriate instruction

number for a particular probe or location. For example, if the probe located in V2 was changed

go to Instruction 27 and change the serial number in location 1 of Instruction 27 (0013 above).

The same holds true for moving sensors or changing the location. If the probes in located in V2

and V3 are swapped the serial numbers also have to be swapped in the program.

Once the program has been changed, click on “save” and when the warning banner comes up

asking you to compile click on “yes.” If there are errors or warnings, stop and contact the

mentor(s). If there are no warnings, proceed with loading the program to the data logger. EdLog

can be closed at this time.

Go back to the main LoggerNet menu bar and click on “Connect.” When the “Connect” screen is

active, choose “BBSSRef” from the left hand menu location under Stations. Once the BBSSRef

logger is highlighted, click on the “connect” button under Control. When communication with

the logger has been established (wires connect) click on “Send” under Program. Choose the

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Keine Kommentare

Campbell NL100 Bedienungsanleitung Seite 20