Campbell RF400 Handbuch PDF herunterladen (Seite 98)

Appendix I. Phone to RF401 Series

If there is a neighboring RF401 network, you should change the

Hopping Sequence of base and remote RF401s to a new setting

to avoid interference.

NOTE

- RX LED Test -

To determine if there is a neighboring RF401 network in

operation using the same hopping sequence as yours, stop

communications on your network and observe RF401 green

LEDs for activity. At this point, any green LED activity would

indicate that there is a nearby network using the same hopping

sequence.

3. POINT-TO-MULTIPOINT COMMUNICATIONS (Transparent Protocol)

PC-Modem --------- COM220-A100/PS100-RF401 --------- RF401-DL1

------------ RF401-DL2

LoggerNet SETUP

a. Setup:

ComPort_1

PhoneBase

PhoneRemote

RF401

RF401Remote

CR10X

RF401Remote_2

CR10X_2

b. ComPort_1 – default settings

c. PhoneBase

1) Maximum Baud Rate – 9600

2) Modem Pick List – per PC’s phone modem

3) Extra Response Time – 0 s

d. PhoneRemote – input base site’s phone number

e. RF401 – make Attention Character: “-“ ; leave the rest defaults

f. RF401Remote – make Radio Address: “1“ ; leave the rest defaults

g. RF401Remote_2 – make Radio Address: “2“ ; leave the rest defaults

h. Dataloggers – default settings, schedule collections as desired

RF401 CONFIGURATION

a. Base RF401

1) Active Interface: ME Master

2) Protocol: Transparent

3) CS I/O ME Baud Rate: 9600

4) All other settings: defaults

I-8

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 125 126

Keine Kommentare

Campbell RF400 Handbuch Seite 98