Campbell RF400 Handbuch PDF herunterladen (Seite 22)

RF401-series and RF430-series Spread Spectrum Radio/Modems

TABLE 2. Lacking 12 V on CS I/O Pin 8

EQUIPMENT SERIAL NUMBER

CR500 < 1765

CR7 700X Bd. < 2779

21X < 13443

CR10 Wiring Panels All (black, gray, silver)

PS512M Power Supply < 1712

When you connect power to the RF401 (through the SC12 cable or the

optional Field Power Cable) you should see the power-up sequence of red

and green LEDs described in Step 1 (assuming datalogger is powered).

Current dataloggers and wiring panels (not mentioned in Table 2) provide

12 V on pin 8. For older products not listed, check for 12 V between CS

I/O connector pin 8 and pin 2 (GND) or contact Campbell Scientific.

c. Configure the remote radio using the same settings as the base radio (see

“e” in Section 3.2.1). This assumes the base radio is set to AutoSense.

3.2.3 Step 3 – LoggerNet Set-up

a. The next step is to run LoggerNet and configure it to connect to the

datalogger via the radio’s point-to-point or PakBus network you have set

up. For point-to-point and PakBus communications, the radios are

represented as direct connect in LoggerNet (see Figure 4). Refer to

Section 5.2 for the LoggerNet setup of point-to-multipoint.

FIGURE 4. Point-to-Point or PakBus communications, select direct

connect as the connection type.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 125 126

Keine Kommentare

Campbell RF400 Handbuch Seite 22