Campbell RF400 Handbuch PDF herunterladen (Seite 21)

RF401-series and RF430-series Spread Spectrum Radio/Modems

- RX LED Test -

To determine if there is a neighboring radio network in operation

using the same hopping sequence as yours, stop communications on

your network and observe your radio’s green LED for activity. A

flashing green LED would indicate that there is a nearby network

using the same hopping sequence.

• Click apply after changing settings.

apx

TECHNOLOGIES INC.

CLASS 2 TRANSFORMER

MODEL NO: AP2105W

INPUT: 120VAC 60Hz 20W

LISTED

2H56

E144634

MADE IN CHINA

OUTPUT: 12VDC 1.0A

HICKSVILLE, NEW YORK

RS232

Pwr

CS I/O

Pwr/TX

MADE IN USASerial #

Program

Antenna

14320

RF400

Spread Spectrum Radio

This device contains transmitter module:

FCC ID: OUR-9XTREAM

The enclosed device complies with Part 15 of the

FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and (2) this device must accept any intererence

received, including interference that may cause

undesired operation.

Logan, Utah

RS232

Pwr

CS I/O

Pwr/TX

MADE IN USASerial #

Program

Antenna

14320

RF400

Spread Spectrum Radio

This device contains transmitter module:

FCC ID: OUR-9XTREAM

The enclosed device complies with Part 15 of the

FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and (2) this device must accept any intererence

received, including interference that may cause

undesired operation.

Logan, Utah

DIFF

GH L

AG H L AG H L AG E1 AG E2 G

DIFF

GH L

AG H L AG H L AG E3 AG G G

910

11 12

P1 G P2 G C8 C7 C6 C5 C4 C3 C2 C1 G 12V 12V

SDM

5V 5V G G

SW 12V

SW 12V CTRL

Logan, Utah

G 12V

POWER

CR10X WIRING PANEL

MADE IN USA

WIRING

PANEL NO.

EARTH

GROUND

CS I/O

AC Adapter

RS-232

CS I/O

Datalogger CS I/O

LoggerNet

FIGURE 3. RF401 Basic Point-to-Point Network

3.2.2 Step 2 – Set Up Remote RF401

a. Connect an antenna (or antenna cable with Yagi or omnidirectional

antenna attached) to the RF401 antenna jack. The separation between the

base RF401 antenna and the remote RF401 antenna can be any convenient

distance (see Section 3.3 and 4.4).

b. Use the SC12 serial cable to connect the datalogger CS I/O port to the

remote RF401 radio’s CS I/O port. The CS I/O port on newer dataloggers

applies power to the remote RF401.

With older dataloggers lacking 12 V on pin 8 (see Table 2), you can

power the RF401 using a Field Power Cable (see above hardware list)

between the datalogger’s 12 V (output) terminals and the RF401’s “DC

Pwr” jack.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 125 126

Kommentare zu diesen Handbüchern

Keine Kommentare

Campbell RF400 Handbuch Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Campbell RF400