Campbell PC208W Bedienungsanleitung PDF herunterladen (Seite 8)

MicroMet Manual Pg. 5

Installing the MicroMet Communications Unit

MicroMet data communications units come in two varieties, one with a 300 watt

transmitter and one with a 100 watt transmitter. Both varieties are functionally

equivalent, but have slightly different component configurations. The MicroMet 100

requires only a single12 volt power source, while the MicroMet 300 requires a

transmitter battery pack and a Power Control Unit which charges the transmitter battery

pack from the 12 volt power source.

The steps involved in installing the MicroMet unit are as follows:

! Mount the MicroMet unit securely to the enclosure wall or mounting panel.

! Mount the Power Control Unit to the enclosure wall or mounting panel (MicroMet 300

only).

! Connect the MicroMet/Power Control Unit interconnect cabling (MicroMet 300 only).

! Mount the CR10X to enclosure wall or mounting panel.

! Connect the MicroMet data cable between the CR10X CS I/O receptacle and the

MicroMet J4 receptacle.

! Connect the Coaxial antenna cable to the Antenna receptacle on the MicroMet.

! Connect the 12 VDC power cable between the site battery and the MicroMet 12

VDC receptacle (MicroMet 100 only).

! Connect the 12 VDC power cable between the site battery and the Transmitter

Battery Pack (MicroMet 300 only).

! Place the Power switch on the Power Control Unit in the “on” position (MicroMet 300

only).

This completes the general installation of the MicroMet data communications unit.

Please remember to verify proper operation of the MicroMet unit before departure (see

Checking MicroMet Communications Performance, pg 14).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 28 29

Keine Kommentare

Campbell PC208W Bedienungsanleitung Seite 8