Campbell Met One 034A-L Spezifikationen PDF herunterladen (Seite 8)

Met One 034B Windset

CM220

CM200 Series Crossarm

FIGURE 3-2. CM200 Series Crossarm with

CM220 Right Angle Mounting Bracket

Attach the sensor cable to the six pin male connector on the 034B. Make sure

the connector is properly keyed. Finger tighten the knurled ring. Route the

sensor cable along the underside of the crossarm to the tripod/tower, and to the

instrument enclosure. Secure the cable to the crossarm and tripod/tower using

cable ties.

4. Wiring

Connections to Campbell Scientific dataloggers are given in Table 4-1. When

Short Cut for Windows software is used to create the datalogger program, the

sensor should be wired to the channels shown on the wiring diagram created

by Short Cut.

TABLE 4-1. Connections to Campbell Scientific Dataloggers

Color

Wire Label

CR800

CR5000

CR3000

CR1000

CR510

CR500

CR10(X)

21X

CR7

CR23X

CR200(X)

Red WS Signal Pulse Pulse Pulse P_LL

Black WS Signal Ref

Green WD Signal SE Analog SE Analog SE Analog SE Analog

Blue WD Volt Excite Excitation

(VX)

Excitation Excitation Excitation

(VX)

White WD Signal Ref

Clear Shield

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 41 42

Keine Kommentare

Campbell Met One 034A-L Spezifikationen Seite 8