Campbell CDM-VW300 Series Handbuch PDF herunterladen (Seite 34)

CDM-VW300 Series Dynamic Vibrating-Wire Analyzers

FIGURE 6-13. Earth ground connections

9. Write or obtain a CRBasic program for the datalogger. Reference Section

7.10, CRBasic Programming, and Appendix G, CRBasic Program

Library.

CDM-VW300 and CDM-VW305 programs use the following CRBasic

instructions:

CDM_VW300Config()

CDM_VW300Dynamic()

CDM_VW300Static()

The CRBasic program must be enabled specifically for the CDM-VW300

or the CDM-VW305. Programs enabled for a CDM-VW300 use a

DeviceType argument of 0 in the CDM_VW300Config() instruction.

Programs enabled for a CDM-VW305 use a DeviceType of 1. Check that

other settings recorded in step 2 are integrated into the CRBasic program.

Do not attempt to use a program written for the CDM-VW300

when using a CDM-VW305. Configurations for a particular

analyzer are deeply rooted in the CRBasic program. Simply

changing the DeviceType argument will not make all the

necessary changes.

NOTE

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 121 122

Keine Kommentare

Campbell CDM-VW300 Series Handbuch Seite 34