Campbell CDM-VW300 Series Handbuch PDF herunterladen (Seite 24)

CDM-VW300 Series Dynamic Vibrating-Wire Analyzers

If COM port CDM-VW300 does not appear, there is a problem

with the installation of the device driver or the creation of the

COM port. See Section 7.1.1, Software and Driver Installation,

for remedial steps.

NOTE

Press Connect in the lower left of the DVWTool window. If DVWTool

connects with the CDM-VW300, the channel list on the DVWTool

interface becomes available and the button at lower left reads Disconnect

as shown in the following figure.

Notice that the fields Device Type, Serial Number, Device Name, and

CPI address are active and populated in the lower portion of the

DVWTool window. Otherwise, the channel list remains dimmed and the

notice Not connected... No data available is displayed at the right of the

channel list, as shown in the following figure.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 121 122

Keine Kommentare

Campbell CDM-VW300 Series Handbuch Seite 24