Campbell CS106 Handbuch

CS106 BarometricPressure SensorRevision: 11/11Copyright © 1995-2011Campbell Scientific, Inc.

CS106 Barometric Pressure Sensor See Table 3-1 Blue – Pressure (VOUT) See Table 3-1 Yellow – Signal Ground (AGND) Continuous 12 VDC Red – 12

CS106 Barometric Pressure Sensor Improper wiring may damage the CS106 beyond repair. WARNING 3.3 5-pin Screw Terminal Plug Connector The datalogger

CS106 Barometric Pressure Sensor FIGURE 3-4. ENC100 is a very small enclosure that can house one CS106. Remember that for the sensor to detect the e

CS106 Barometric Pressure Sensor 4. Programming The CS106 sensor is measured using the singled-ended voltage measurement instruction (VoltSe in CRBas

CS106 Barometric Pressure Sensor 4.2 Program Examples 4.2.1 Example 1 – Sample Program for CR1000 (CRBasic) Datalogger 'CR1000 Datalogger Publ

CS106 Barometric Pressure Sensor ;Measure CS106 at the top of the hour ; 2: If time is (P92) 1: 0 Minutes (Seconds --) into a 2: 60 Inter

CS106 Barometric Pressure Sensor 4.3 Long Lead Lengths There is a 0.06 mV/foot voltage drop in the CS106 signal leads. This voltage drop, in long le

CS106 Barometric Pressure Sensor The corrections involved can be significant: e.g. at 1000 mb and 20°C, barometric pressure will decrease by 1.1 mb fo

CS106 Barometric Pressure Sensor 12

Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com • info@campbel

Warranty “PRODUCTS MANUFACTURED BY CAMPBELL SCIENTIFIC, INC. are warranted by Campbell Scientific, Inc. (“Campbell”) to be free from defects in materi

Assistance Products may not be returned without prior authorization. The following contact information is for US and international customers residing

CS106 Table of Contents PDF viewers: These page numbers refer to the printed version of this document. Use the PDF reader bookmarks tab for links to

CS106 Barometric Pressure Sensor 1. General The CS106 analog barometer uses Vaisala’s Barocap® silicon capacitive pressure sensor. The Barocap senso

CS106 Barometric Pressure Sensor Supply Voltage Control: When enabled with an internal jumper, the CS106 is on continually. When disabled, the CS106

CS106 Barometric Pressure Sensor Jumper FIGURE 3-1. CS106 Jumper Set to Shutdown Mode 3.2 Datalogger Connection Before connecting the barometer to t