Campbell RAWS-H Remote Handbuch PDF herunterladen (Seite 16)

RAWS-H Remote Automated Weather Station

FIGURE 5.4-1. GOES Transmitter

5.4.2 Wiring, GOES Transmitter (part #TX320)

The GOES transmitter (part #TX320) is mounted inside the RAWS

environmental enclosure and the transmitter connections are described below;

GOES Transmitter TX320 Connection inside the RAWS environmental

enclosure

GOES TX320 “CSI/O” Port --to-- CR1000 PC Board “CSI/O” Port using

an *SC12 Cable

GOES TX320 “GPS Port” --to-- GPS Antenna Cable

GOES TX320 “RF Out” --to-- GOES Antenna Cable

GOES TX320 “Power Port” --to-- Battery Cable Junction Connector

*Note: The SC12 Cable ships with the RAWS Weather Station.

5.4.3 Troubleshooting, GOES Transmitter (part #TX320)

If a problem with the GOES transmitter (part #TX320) is suspected, the TX320

may be checked by measuring the +12 V and Ground terminal on the CR1000

PC-board wiring panel. Acceptable readings are +11 VDC to +14 VDC.

Check the SC12 cable connection between the CR1000 wiring panel and the

TX320. Press the TX320 diagnostic button to query the state of the

transmitter.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 29 30

Keine Kommentare

Campbell RAWS-H Remote Handbuch Seite 16