Campbell RavenXTG GPRS/EDGE Spezifikationen Seite 1

Raven110 GPRS/EDGEAirLink Cellular ModemRevision: 12/07Copyright © 2006-2007Campbell Scientific, Inc.

Raven110 GPRS/EDGE AirLink Cellular Modem PN 18285 1 dBd Omni Directional Antenna PN 14454 9dBd Directional Yaggi Antenna PN 14453 Half-Wave Dipole

Raven110 GPRS/EDGE AirLink Cellular Modem 5. Program the Raven110 Modem The following software is used to program the modem: AirLink’s Wireless Ace 3

Raven110 GPRS/EDGE AirLink Cellular Modem Click the Connect icon in the Configuration Panel to open the connection options dialogue box. Select PPP,

Raven110 GPRS/EDGE AirLink Cellular Modem Baud rate can be changed from 9600, to a higher baud rate supported by the datalogger (e.g., 115200 for a C

Raven110 GPRS/EDGE AirLink Cellular Modem For a custom APN, or APN through a third party provider (e.g. Crossbridge Solutions), enter the APN as shown

Raven110 GPRS/EDGE AirLink Cellular Modem 6. LoggerNet/PC400W Software Setup The Device Map is configured from the “Setup” button on the LoggerNet/PC

Raven110 GPRS/EDGE AirLink Cellular Modem 7. Troubleshooting If LoggerNet/PC400W software is unable to establish a connection with the modem: 7.1

Raven110 GPRS/EDGE AirLink Cellular Modem The modem has to be configured using Wireless Ace 3G as described in Section 5. Modem settings have to be ch

Raven110 GPRS/EDGE AirLink Cellular Modem The Device Port gets changed from the default 12345 to 3001 when the template file is loaded into the modem

Raven110 GPRS/EDGE AirLink Cellular Modem Verify the APN has been entered in the NETAPN and +CGDCONT fields as shown above (where gprs02.Motient.net

Warranty and Assistance The RAVEN110 GPRS/EDGE MODEM is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship un

Raven110 GPRS/EDGE AirLink Cellular Modem Try adding a few seconds (no more than five seconds) of extra response time to the datalogger or PakBus port

Raven110 GPRS/EDGE AirLink Cellular Modem FIGURE 7-1. Wireless Ace status page showing communications with modem. 17

Raven110 GPRS/EDGE AirLink Cellular Modem 18 This is a blank page.

Appendix A. Wireless Ace Setup without Template File Wireless Ace 3G is used to program settings in the Raven100 and Raven110 modems to make the mode

Appendix A. Wireless Ace Setup without Template File • S23 – Configure Serial Port – The baud rate needs to be configured to match a valid datalogge

Appendix A. Wireless Ace Setup without Template File • S0 – TCP Auto Answer – Set to On • TCPT – TCP Idle Timeout -- Set to a reasonable value lik

Appendix A. Wireless Ace Setup without Template File A-4 This is a blank page.

Appendix B. Installation of SIM Card in the Raven110 The Subscriber Identity Module (SIM) in the Raven is a smartcard securely storing the key identi

Appendix B. Installation of SIM Card in the Raven110 FIGURE B-3. Tray Button 5. Slide the tray out of the slot. FIGURE B-4. Empty SIM Tray Inse

Appendix C. Configuring the Raven for PPP The Raven template file configures the Raven to function as a serial server. As a serial server, the modem

Raven110 Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab

Appendix C. Configuring the Raven for PPP Use WirelessAce to configure the following PPP settings: • HOSTPRIVMODE = 1 • HOSTPRIVIP = 192.168.1.1 Th

Appendix C. Configuring the Raven for PPP Datalogger Settings: Using the Device Configuration Utility, configure the following setting on the TCP/IP

Appendix C. Configuring the Raven for PPP Using the Device Configuration Utility, fix the RS232 Baud Rate to “115200 Fixed” from the “Port Settings”

Appendix C. Configuring the Raven for PPP Example CR1000 Program The following example sends an email message when an alarm condition is True. Both

Appendix C. Configuring the Raven for PPP C-6 This is a blank page.

Appendix D. Understanding APNs [Note: The following data is specific to the U.S. Cingular network; however, it is applicable to any GSM network, alth

Appendix D. Understanding APNs D-2 These mobile connections are visible on the public Internet so security and traffic blocking need to be taken into

This is a blank page.

Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campbells

Raven110 Table of Contents ii Figures 4.2-1. Modem Interface Options... 4 4.2-2. An

Raven110 GPRS/EDGE AirLink Cellular Modem 1. General Description This manual provides information for interfacing the AirLink Raven110 cellular modem

Raven110 GPRS/EDGE AirLink Cellular Modem Point Name (APN), and the device to “Mobile Terminated”, which makes the modem accessible by LoggerNet over

Raven110 GPRS/EDGE AirLink Cellular Modem 4. Configuration 4.1 Base Station Requirements for Raven110 PC running Campbell Scientifics’ LoggerNet or

Raven110 GPRS/EDGE AirLink Cellular Modem SC105 interface connects the modem to a datalogger’s CS I/O port; recommended for dataloggers with the PakB

Raven110 GPRS/EDGE AirLink Cellular Modem • PN 13493 Raven Mounting Kit—includes mounting hardware for securing the modem to below referenced environ