Campbell CR7 Bedienerhandbuch PDF herunterladen (Seite 35)

SECTION 1. FUNCTIONAL MODES

1-7

TABLE 1.7-1. *C Mode Entries and Codes

Key Display

Entry ID: Data Description

*C 12:0000 Enter current password.

If correct, then advance,

else exit *C Mode. 12:00

indicates *C Mode is not

in PROMs. If security is

disabled, *C advances

directly to window 1.

A 01:00 Window 1, enter

command:

00 = disable security and

advance to window

2; subsequent *0 or

*6 enables security.

01 = security remains

enabled, but it

advances to window

2 and allows entry of

a new password.

A 02:XXXX Set new password

(XXXX is current

password).

A Returns to window 1.

Entering 0000 disables

security (window 1 must

be set to 0).

1.8 *D MODE -- SAVE OR LOAD

PROGRAM

The *D Mode allows the user's program

information in the *1, *2, *3, *4, *A, *C (if OSX-

0), and *B Modes to be output to or loaded from

printer/computer (ASCII) or SM192/716 Storage

Module. Table execution and on-line printer

outputs are suspended while in the *D Mode.

When *D is keyed, the CR7 will display "13:00".

TABLE 1.8-1. *D Mode Commands

Command Description

1 Save ASCII Program

2 Load ASCII Program

71 Save/Load/Clear Program

from Storage Module

A command is entered by keying the command

number and A. When Command 1, 2, or 71 is

entered, the command number is displayed in

the ID field. The user must then key in a baud

rate code for command 1 or 2 or the command

code for the Storage Module (Table 1.8-2).

After the code is keyed in, key A to execute the

command. After a command is executed,

"13:0000" is displayed; *D must be entered

again before another command can be given.

If the CR7 program has not been compiled

when a command to save the program is

entered, it will be compiled before the command

is executed.

TABLE 1.8-2. *D Mode Baud Rate and

Storage Module Codes

BAUD RATE STORAGE MODULE

CODES COMMAND CODES

0 - 300 baud 1X Save Program X to

1 - 1200 Storage Module

2 - 9600 (X=1-8)

3 - 76,800 2X Load Program X from

Storage Module

(X=1-8)

3X Erase Program X from

Storage Module

(X=1-8)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 185 186

Kommentare zu diesen Handbüchern

Keine Kommentare