
AVW200-series 2-Channel Vibrating Wire Spectrum Analyzer Modules
5.2.2 Measurement
The Deployment/Measurement Tab is used to configure the SDI-12 Address,
multiplexer type, begin frequency, end frequency, and excitation (see FIGURE
5-3).
FIGURE 5-3. Deployment/Measurement Tab in DevConfig
The Begin Frequency, End Frequency, and excitation parameters
in DevConfig are only used for the RS-232 (terminal commands)
and SDI-12 communication modes. When using the RS-232
(PakBus) or RF (PakBus) communication modes, the settings for
the Begin Frequency, End Frequency, and excitation parameters
are entered in the AVW200() CRBasic instruction (see Section
6,
Programming
(p. 37)).
Description of the Measurement Settings follows:
SDI-12 Address—select an address if using SDI-12. Otherwise use the default
value of 0.
29
Kommentare zu diesen Handbüchern